Sigma C4 Manuale Utente Scaricare il pdf (Pagina 96)

C4 Manual Rev 7.5.2

Once you have set the program pointer to a step, you can enter new program

information by following the procedure in Section 6.4 or run a program that begins

at that step as detailed in Section 6.7.

IMPORTANT: When placing more than one program in memory, all programs

except the last one must end with SUBSTEP 3 = 100, or a non terminating loop, in

order to prevent separate successive programs from automatically running

successively. It is good programming practice to place an End of Program

(SUBSTEP 3 = 100) command at the end of every program. This will assure that

program data that may be entered into higher step numbers at a later time will

not have unexpected results when the initial program is run.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 119 120

Nessun commento

Sigma C4 Manuale Utente Pagina 96